
SETTING UP A HENRI STUDIO VESUVIO FOUNTAIN
1) Position the fountain bowl on a level, firm base which will not
change over time. Note that a channel runs under the bowl to the
center hole. This allows for two power cords and an air tube to be
pulled out of the bowl. Make sure that the positioning of the
bowl will allow for these lines to be pulled through.
2) Find the long air tube and the light. Place the two-hole stopper
around the air tube and the light power cord, allowing about 6” of
each to extend about the stopper.
3) Attach the “H” shaped tee assembly to the end of the air tube
as shown in the drawing below.
4) Attach a short air tube and air stone to each of the remaining
“H” tee assembly ends as shown in the drawing below.
5) From the top of the concrete vase (you can tip it or lay it down
according to your preference) insert both the other end of the long
air tube and of the light power cord through the large hole in the
floor of the vase. Pull them through gently until the two-hole
stopper is near the hole. Then firmly press the stopper into the hole.
6) From the top of the vase, insert the short brass nipple into the
other, smaller hole in the vase floor.
7) Thread the brass check valve onto the nipple.
8) Now moving under the vase, thread the ½” barbed adapter into
the smaller hole.
9) Attach the water tube to this adapter and secure with a clamp.
10) Slip the restrictor onto the other end of the water tube and
tighten it enough that it holds firmly in place on the tube, about 6”
from the open end.
11) Thread the ¾” barbed adapter into the water pump exhaust (top
of pump).
12) Attach the open end of the water tube to the pump exhaust
adapter and secure with a clamp.
Comentários a estes Manuais