None RP-34-100 Guia de Instalação descarregar pdf (Página 10)

2. Determine Zone Boundaries

Before tubing is installed, visually inspect the area to determine the

zoneboundaries.Thishelpsdeterminewheretherstcircuitistobe

placed, while identifying any obstacles.

3. Conﬁrm Tubing Requirements

• Measure the distance from the

manifolds to the farthest point in

the zone.

• Make sure the minimum circuit length

is at least twice this distance. If not, the

tubing will not be long enough to reach

the farthest point and still have enough

length to return to the manifold.

4. Install Tubing

• Pull one end of tubing off the unwinder

andattachittotherstbarbonthe

supply manifold.

• Lay the tubing along the perimeter

walls to the farthest point in the zone,

keeping the tubing 6"-8" (152.4 mm -

203.2 mm) from the edge of the slab.

This will help protect the tubing from

possible penetrations later on when the

nalﬂoorcoveringisinstalled.

• Pay attention to the footage marking on

the tubing and cut at the correct length.

• Bend supports may be used to secure

the tubing as it transitions from the thin

slab to the wall.

• In most thin slab applications, built-ins

such as cabinets, showers, and walls

are already in place before the thin slab

is poured. Tubing is generally run around

these “built-ins”.

• Most structural code requirements

restrict the amount of material that

can be removed from a wall member.

It is advised to run the tubing through

doorways, or other openings,

whenever possible.

Supply Manifold

Return Manifold

Thin Slab

20 8

(6.3 m)

16 8

(5.1 m)

Supply Manifold

Return Manifold

Thin Slab

Manifold

Location

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Comentários a estes Manuais

Sem comentários

None RP-34-100 Guia de Instalação Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com não None RP-34-100