Assembly Instruction
Item#
* * WARNING * *
Read these instructions carefully and keep the fountain power off until the following
assembly process is completed.
Notes:
Choose an appropriate location for the fountain.
Excessive weight or pressure on any of the fountain sections may cause it to
fall. Keep pets, children,
or anyone from sitting, leaning, or climbing on any of the fountain components.
While fountain is designed to operate as splash free as possible, some water splashing out of the
fountain is inevitable. Place the fountain in a location where any splashing will not cause damage.
The National Electric Code requires that a ground fault circuit interrupter (GFCI) be used in the
branch circuit supplying fountain pump and other pond equipment. Seek your electrical supplies
dealer for this device.
Always keep the fountain working properly with sufficient water and clean of debris and dirt to
ensure proper functioning of the pump.
If necessary, clean the fountain with a soft cloth and change the water frequently. Due to water
evaporation, you may see a buildup of white residue on the fountain surface from mineral content
in the water supply. To prevent such buildup, regularly clean the fountain with soap and water, do
not use anything abrasive, which may damage the applied finish.
See the pump instructions for pump safety, maintenance, and warranty information.
Keep this manual for future reference.
Installation & Assembly
Take out all packaged parts.
Place the fountain on a level surface, away from areas where it is likely to get clogged with leaves
and make sure that the cable will reach the socket.
Follow steps to assemble as illustrated below.
Fill the reservoir with clean water or pipe water into fountain from the backdoor. Always make sure the
water can submerge the pump completely to work properly and prevent the pump damage. Plug in
the pump and adaptor then switch on, the water will start to flow in minutes.
1
Step (1)
.
Step (2).
Step (3).
"+/ Max ." will increase the flow rate and moving it towards "-/Min" will decrease it.
On some
pumps, flow regulator may be turned clockwise or counterclockwise to adjust.
Adjust the pump flow rate to achieve the desired effect and to
minimize any splashing. Splashing
can
occur if the flow rate is too high or the reservoir is too full. The flow rate can be
increased or
decreased by moving the flow rate control slider on the pump body. Moving the
switch towards
Pull out the plastic tube from the bottom of the vase, then connect it to pump outlet
also pull out the LED cable,connect it to transformer.
Join the top part and the reservoir.
Turn the
vase so that it locks onto the reservoir.
Add water to the reservoir, plug in.
Y96591
(1 páginas)
(1 páginas)
(2 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais